Back to Blog
![]() Select Device Type = Wireless, Configuration Name = wlan0 (or wlanX where X is the next wireless card number), HardwareĬonfiguration Name = bus-pci-0000:XX:XX.X (replace the X’s with the pci location of the device from the output of ‘lspci After that, use Yast to add new networkĬard. Order to work with Suse 10 x86_64, install ndiswrapper and driver then run modprobe ndiswrapper. Suse 10 requires some extra help though with this wlan card. * Other: Using Ndiswrapper 1.5 and the above driver with no problems. Only the Acer 64bit drivers have worked under this OS Note: If you are using a WEP key in hexadecimal format (numbers and letters from A to F) make sure you proceed it with a 0x whenĭriver: bcmwl5.inf, BCMWL564.SYS, also had to use the 64 bit version from – Note: the Linuxantĭriverloader drivers (64bit) will not work for this card. ![]() If you want, you can check here to activate it at boot time. After this you can now go to configure it by running the “Network” program from system settings (or On Fedora: As soon as the card is recognized it and the ndiswrapper Server and associated with the linksys router running dd-wrt 23sp2. Running from root prompt type ndiswrapper -m to install an alias for you so the card will activate on boot. Ndiswrapper -l should now show net8185 : driver installed deviceįrom root prompt type modprobe ndiswrapper it will pause for a moment and then the lights on the card should come on. Ndiswrapper -a 1799:701f net8185 hit enter this associates the net8185 driver with the device ID of the belkin card. Shows net8185 driver installed we now have to get the device id from root prompt type lspci -n at the bottom of the list is the belkinĬard card ID info 1799:701f write this down you will need it for the next portion of the installation. Root password, then type ndiswrapper -i net8185.inf in the folder where you extracted the driver files hit enter. Open a terminal and change to user root with su and There will be 3 files net8185.inf net8185.sys net8185.cat. You have to unzip the driver into aĭirectory you can access. You will have to try it on your distribution of *nix. Installation : Install most current ndiswrapper and dkms for you *nix system as of this writing ThisĬard is working in mandriva and fedora.
0 Comments
Read More
Leave a Reply. |